Quantity: 2
License plate bulb Type: Incandescent (W2.1x9.5 d)
Quantity: 1
Power: 12V - 5W
03_30
03_31
Front light group (03_30, 03_31, 03_32, 03_33, 03_34)
To access the bulbs:
- Remove the PIAGGIO clip-on badge and undo the screw «A».
- Working on both sides of the vehicle, undo the screw «B» and remove the front
headlight cover.
- Working on both sides of the vehicle, undo the three screws «C» and the two screws
«D» located inside the front mudguard.
- Take the headlight assembly off its housing.
To reassemble, repeat the operation but in reverse order.
To replace the tail light bulbs «E», take out the rubber bulb holder and slide off the
bulb.
In order to replace the high-beam «F» and low-beam «G» bulbs, remove the rubber
cap, take out the bulb holder by releasing the springs and slide off the light bulb.
In order to replace the turn indicator bulbs «H», take out the right bulb holder by turning
it anticlockwise, or clockwise, if it is the left one, and then slide off the bulb by pushing
and turning it anticlockwise.
57
To Next Page
Loading...
Need help?
General