03_35
Headlight adjustment (03_35, 03_36, 03_37, 03_38)
Proceed as follows:
1. Position the unloaded vehicle, in running order and with the tyres inflated to the
prescribed pressure, onto a flat surface 10 m away from a half-lit white screen; make
sure the vehicle axis is perpendicular to the screen.
2. Turn on the headlight and check that the limit of the projected light beam is not
higher than 9/10 or lower than 7/10 of the height of the centre of the headlight from
the ground.
3. Otherwise, adjust the headlight.
N.B.
THE ABOVE PROCEDURE COMPLIES WITH THE EUROPEAN STANDARDS RE-
GARDING MAXIMUM AND MINIMUM HEIGHT OF LIGHT BEAMS. REFER TO THE
STATUTORY REGULATIONS IN FORCE IN EVERY COUNTRY WHERE THE VE-
HICLE IS USED.
03_36
In order to adjust the light beams:
- Remove the PIAGGIO clip-on badge and undo the screw «A».
- Working on both sides of the vehicle, undo the screw «B» and remove the front
headlight cover.
- Act on screws «I» in order to aim the light properly.
CAUTION
DO NOT CARRY ANY GARMENTS ON THE FRONT HEADLIGHT ASSEMBLY.
THIS MAY CAUSE BULBS TO OVERHEAT AND THEREFORE ABNORMAL
WEAR.
59
To Next Page
Loading...
Need help?
General