03_17
03_18
Headlightadjustment (03_17, 03_18)
Position the unloaded vehicle a flat surface and at 10 m away from a white screen
located in the dark. Make sure that the vehicle is perpendicular to the screen. Draw a
horizontal line on the screen at a height of 83 ÷ 85 cm from the ground.
Start the engine, turn on the headlight, turn on the low-beam light and orientate it so
that the horizontal borderline between the dark and the light area is not higher than
the horizontal line drawn on the screen. To remove the headlight, unscrew the screw
«A» located below it.
Before adjusting the headlight, check that the tyres have the correct pressure as in-
dicated in the «Tyres» section
03_19
Frontdirectionindicators (03_19)
To replace the bulb of the front turn indicators unscrew the 4 fixing screws «C». To
take out the bulb from the bulb holder, rotate the bulb holder clockwise and remove it
from its seat. To remove the bulb, push and rotate it counterclockwise.
38
To Next Page
Loading...
Need help?
General