03_29
delveicolo (03_29)
We recommend carrying out the following operations:
1. General cleaning of the vehicle.
2. With the engine off and the piston at the bottom dead centre position, remove the
spark plug, and pour 1÷ 2 cm³ of recommended oil through its opening. Press the
engine start pedal 3 or 4 times letting the engine perform a few revolutions slowly,
then replace the spark plug.
3. Drain off all the vehicle fuel; spread antirust grease on the unpainted metal parts;
keep the wheels off the ground, by resting the chassis on two wooden wedges.
4. For the battery, follow the procedures described in the «Battery» section.
5. Drain the petrol from the carburettor float chamber through the bleed cap.
Recommended products
eni i-Ride PG 5W-40
Synthetic based lubricant for high-performance four-stroke engines.
JASO MA, MA2 - API SL - ACEA A3
03_30
Cleaningthevehicle (03_30)
Use a low pressure jet of water to soften the caked dirt and mud deposited on the
painted surfaces. Once softened, sponge off mud and dirt using a car body sponge
soaked in a car body shampoo and water solution (2-4% of car shampoo in water).
Then rinse with abundant water, and dry with a shammy cloth. For the engine exterior,
use petrol, a brush and clean cloths. Petrol can damage paintwork. Remember that
any polishing with silicone wax must always be preceded by washing.
45
To Next Page
Loading...
Need help?
General