• An individual ID number and ID data (AACS, CPRM, BD+, Windows Media DRM, and MAC address)
must be input at the same time. All data are determined according to the data on the ID data disc. If the
number and data are not set correctly with the following procedure, the unit does not work properly.
You will find the ID number to be labeled on the rear panel.
This setting is Necessary When:
• When the DRIVE Assy or MAIN Assy is replaced.
Important: If no ID label is found on the rear panel, write down the specified ID number by checking it
on the version check screen ([ESC] + [DISP]).
• Input the ID number while the unit is in Stop mode.
• After the data are read from the ID data disc, the disc will automatically be unloaded.
• Each time a key input succeeds, the screen background becomes blue. If a key input fails, the screen
background becomes red.
[Purposes]
[Tools to be used]
[Notes]
Remote control unit for servicing
(GGF1067)
ID Disc for Blu-ray Player
(GGV1334)
After updating the firmware, set the ID No. and ID data.
To Next Page
Loading...
Need help?
General
