07
38
En
Adjusting the video
1 Select and set Display Setting Video Adjust.
Use / to select, then press ENTER.
2 Select Custom.
Use / to select, then press ENTER.
3 Select the item and change the setting.
Use / to select the item, then use / to change the
setting. Once the setting is completed, press
RETURN to close the settings screen.
List of setting items
Setting the IP address
1 Select and set Network IP Address Setting
Next Screen.
Use / to select, then press ENTER.
2 Set IP address.
Use /// to set the IP address of the player or DNS
server, then press ENTER.
• Auto Set IP Address
On – The player’s IP address is obtained
automatically. Select this when using a broadband
router or broadband modem that has a DHCP
(Dynamic Host Configuration Protocol) server
function. This player’s IP address will automatically
be allocated from the DHCP server.
Off – The player’s IP address must be set manually.
Use the number buttons (0 to 9) to input the IP
address, subnet mask and default gateway.
Caution
• Some time is required for the IP address setting.
Note
• Once the IP address is set, select [Connection Test] to
check that the unit is properly connected.
• For information on the DHCP server function, refer to
the operating instructions for the network device.
• You may need to contact your Internet service
provider or network administrator when inputting the
IP address manually.
Setting the proxy server
Only set the proxy server if so instructed by your Internet
service provider.
1 Select and set Network Proxy Server Next
Screen.
Use / to select, then press ENTER.
2 Select and set Use or Not use at Proxy Server.
Use / to change, then press .
• Use – Select this when using a proxy server.
• Not use – Select this when not using a proxy server.
If you have selected Use, proceed to step 3.
Options
Screen Saver Off The screen saver is not activated.
1 min The screen saver will be activated if no operation has been performed for
more than one minute/two minutes/three minutes. Operating the remote
control can deactivate the screen saver.
2 min
3 min
Auto Power Off Off Select this if you do not want the power to turn off automatically. This is the
default setting for models other than European models.
10 min The power will be automatically turned off if no operation has been performed
for more than 10 minutes/20 minutes/30 minutes. The default setting for
European models is 30 minutes.
20 min
30 min
Quick Start On Select to shorten the required time to boot up.
Off Select to perform normal bootup.
Update USB Storage Select the method of software updating (page 40).
Network
Load Default Restore the settings to the factory default.
System Information Check the system version number.
BUDA BUDA Information Display and set up the BUDA data on the connected USB device (page 39).
BUDA Setup
Setting Options Explanation
Item Description
Brightness Select this to adjust the TV screen’s
brightness.
Saturation Select this to adjust the TV screen’s
saturation.
Hue Select this to adjust the color (green and
red) balance of the TV screen.
Contrast Select this to adjust the TV screen’s
contrast.
Sharpness Choose the level of sharpness.
CTI (Color Transient
Improvement)
Provides images with clearer color
contours.
BDP-160_EN_ASEAN.book 38 ページ ２０１３年７月１７日 水曜日 午後４時１２分
To Next Page
Loading...
Need help?
General
