Pioneer CT-W530R User Manual

TROUBLESHOOTING
Incorrect
operations
are
aften
mistaken
for
trouble
and
malfunctions.
if
you
think
that
there
is
something
wrong
with
this
component,
check
the
points
below.
Sometimes
the
trouble
may
lie
in
another
component.
Investigate
the
other
components
and
electrical
appliances
being
used.
{f
the
trouble
cannot
be
rectified
even
after
exercising
the
checks
listed
below,
ask
your
nearest
PIONEER
authorized
service
center
or
your
dealer to carry out repair work.
Symptom
Probable Cause
POWER
Cannot turn power on.
The power plug is removed.
The component (stereo amplifier, audio timer,
etc.) to which the power cord is connected is
off.
insert the power plug correctly.
Turn the stereo amplifier or audio timer on.
CASSETTE DOOR
is
The door does not open.
The deck is not in stop mode (tape is moving}.
Power was turned off with the tape moving.
Press the stop { M} button
Turn power on.
—-
The door doés not close. The cassette is not properly loaded. * Reinsert the cassette.
—
PLAYBACK
|
—
Immediately
stops.
The
tape
is
completely
wound.
*
Play
back
in
the
opposite
direction.
The tape is slack. * Rewind the tape.
* Take up slack (see page 5).
The
Jevel
meter
does
not
The
tape
is
not
recorded.
*
Replace
the
tape
with
a
recorded
one,
work,
The
tape
head
is
dirty.
*
Clean
the
head
{see
page
15).
r
No
sound
The
amplifier
input
selector
is
not
correctly
set.
*
Set
the
amplifier
input
selector
correctly.
The amplifier volume level setting is too low. * Turn the amplifier volume control up.
Connection problems (wrong connection, cord * Connect securely.
removed, poor contact, broken wire).
POOR SOUND QUALITY
Unstable or interrupted The head, pinch rollers and capstans are dirty. * Clean (see page 15).
sound
The
tape
is
not
uniformly
wound.
*°
Completely
fast-forward
or
rewind
the
tape.
[
No
high
frequencies
A
tape
recorded
without
Dolby
NR
is
being
*
Set
DOLBY
NR
switch
@
to
OFF.
played back with DOLBY NR switch in the B or
C position.
The head is dirty. * Clean the head {see page 15).
High frequencies are em- A Dolby NR-encoded tape is being played back | * Set DOLBY NR switch 49 to the same position
|
phasized.
with
DOLBY
NR
switch
in
the
OFF
position.
used
for
recording.
Sound from previous The head is dirty. * Clean the head {see page 15).
recordings remains when H
re-recording a tape.
The
sound
is
distorted.
Recording
level
is
too
high.
*
Turn
REC
LEVEL
control
@)
down
when
record-
| ing (see page 11).
The recorded signal itself is distorted, *¢ Repiace the cassette.
The head is dirty. * Clean the head (see page 15}.
be — :
Too much noise Hi noise tape is being used. * Replace the cassette.
Incomplete insertion of a connection cord, poor ¢ Check cennections. i
contact.
Recording level is too low. * Turn REC LEVEL control (3) up when recording
{see page 11).
The head is dirty. Ciean the head {see page 15).
The head is magnetized. Demagnetize with a head demagnetizer.
a
14
<RRBI058>

Pioneer CT-W530R Specifications

General

Brand	Pioneer
Model	CT-W530R
Category	Cassette Player
Language	English