En
55
10
Controlling the rest of your system
off, followed by this receiver (switch of all the
zones becomes off).
! In order to avoid accidently switching off a
DVD recorder that is currently recording, no
DVD recorder power off codes are sent.
Erasing the settings for the
multi-operation
This erases all the settings programmed in the
remote control for the multi-operation.
1 Press and hold RCU SETUP, then press
‘8’ for three seconds.
Release the button after the LED flashes once.
The LED continues to flash.
! To cancel the preset setup mode press
RCU SETUP.
2 Press the input function button
containing the program you want to
cancel or the u SOURCE button for three
seconds.
If the LED lights for one second, the erasing has
been successfully completed.
Resetting the remote control
settings
Use this procedure to reset all the remote con-
trol’s settings to the factory default.
! When preset codes are set, all the signals
learned in the input function buttons are
cleared. This function is convenient when you
want to reset some but not all of input function
buttons.
1 Press and hold RCU SETUP, then press
‘0’ for three seconds.
Release the button after the LED flashes once.
The LED continues to flash.
2 Press and hold the ENTER button for
three seconds.
If the LED lights for one second, the erasing has
been successfully completed.
Default preset codes
Input function button Preset code
DVD
2158
BD
2160
DVR/BDR
2150
HDMI
2159
TV/SAT
0116
CD
5066
TV CTRL
0116
To Next Page
Loading...
Need help?
General
Weight and Dimensions
