25
FEATURES AND CONTROLS
Instrument Cluster
Rider Information Center
The rider information center is located in the instrument cluster. All segments will light up
for 2.5 seconds at start-up.
Tip: If the instrument cluster fails to illuminate, a battery over-voltage may have occurred and the
instrument cluster may have shut off to protect the electronic speedometer. If this occurs, take the
vehicle to your Polaris dealer for proper diagnosis.
1. Gear Indicator - This indicator displays
gear shifter position.
H = High Gear
L = Low Gear
N = Neutral
R = Reverse Gear
P = Park
2. AWD Indicator - This indicator illumi-
nates when the AWD switch is in the AWD
position.
3. Engine Hour Display Indicator
4. Service Interval/Diagnostic Mode Indi-
cator
5. Low Battery and Over Voltage - This warning usually indicates that the vehicle is
operating at an RPM too low to keep the battery charged. It may also occur when the
engine is at idle and high electrical load (lights, cooling fan, accessories) is applied.
Drive at a higher RPM or recharge the battery to clear the warning.
6. Odometer/Tachometer/Tripmeter/ Hour Meter
7. Fuel Gauge - The segments of the fuel gauge show the level of fuel in the fuel tank.
When the last segment clears, a low fuel warning is activated. All segments will flash,
FUEL will display in the LCD, and the speedometer needle will blink. Refuel immedi-
ately.
8. Check Engine Warning Indicator - This indicator serves two purposes. The word HOT
displays if the engine overheats. It also appears if an EFI-related fault occurs. Do not
operate the vehicle if this warning appears. Serious engine damage could result.
To Next Page
Loading...
Need help?
General
