26
FEATURES AND CONTROLS
Instrument Cluster
Rider Information Center
Standard Modes
Use the yellow mode button located under the speedometer to toggle through the mode
options. See page 18.
Odometer Mode
The odometer records the miles traveled by the vehicle.
Trip Meter Mode
The trip meter records the miles traveled by the vehicle on each trip if it's reset before each
trip. To reset the trip meter, select the trip meter mode. Press and hold the mode button until
the total changes to 0.
Tip: In the Rider Information Center, the trip meter display contains a decimal point, but the odometer
displays without a decimal point.
Hour Meter Mode
This mode logs the total hours the engine has been in operation.
Tachometer Mode
The engine RPM is displayed digitally. Small fluctuations in the RPM from day to day may
be normal because of changes in humidity, temperature and elevation.
Diagnostic Mode
The wrench icon will display when the gauge is in the diagnostic mode. To exit the diagnos-
tic mode, turn the key switch off and on. Any movement of the tires will also cause the gauge
to exit the diagnostic mode.
To enter the diagnostics mode:
1. Turn the key switch off and wait 10 seconds.
2. Place the transmission in neutral.
3. Hold the mode button and turn the key switch on. Release the switch as soon as the dis-
play is activated.
4. Use the mode button to toggle through the diagnostic screens.
To Next Page
Loading...
Need help?
General
