32
FEATURES
Instrumentation
MFD Digital Disp lay Programs
Press the MODE button to cycle through the three MFD program s:
Performance, Engine and History. Each program will remain in the
display until another is select ed.
NOTE: The analog will always display either MPH or engine RPM
(whichever setting is selected) regardless of the display
program being viewed.
Performance Program
The Performance Program automatically displays either speed or
tachometer, whichever is opposite the analog display. S ee page 31. It
also displays electrical system voltage and fuel levels.
While in the Performance mode, press the SET button to cycle through
the odometer, Trip 1, Tri p 2, Trip F and C lock settings.
Trip Settings
Trip 1 and Trip 2 are odomet ers used to
check fuel mileage or to keep track of
distance traveled.
1. To reset a trip odometer to zero,
entertheTrip1orTrip2display.
2. P ress and hold the SET button for
two seconds.
Trip F automatically displays if the fuel
level is low. The fuel symbol and the
last fuel bar on the MF D gauge will
blink when the fuel level reaches 1/8th
tank. The Trip F odometer records
distance traveled until enough fuel is
added to raise the level above 1/4 tank.
The fuel symbol and the fuel bar will
continue to blink until the fuel level is
above 1/4 tank. The Trip F odometer
will automatically reset to zero after
refueling.
Odometer Setting
The odometer records the vehicle’s
total distance traveled since
manufacture. The odometer cannot be
reset.
To Next Page
Loading...
Need help?
General
