Page 37
English
User Issue Possible Cause Suggested Solution
The cleaner is not cleaning
the pool effectively.
Filter canister is full or dirty. Dispose of debris and thoroughly clean the lter
canister with mild soap and a soft brush. Then,
re-submerge the cleaner (see: Clean the Filter
Canister).
Brushes are worn. Check the wear indicator(s). (See: Replacing
Wear Parts).
Cable is excessively tangled. Untangle the twisted cord and lay in sun to
reduce memory. (See: Cord Tangling).
Dismissing an Error Code
From the Control Unit:
After you have completed the troubleshooting solution steps, press any key (except the phone icon) to
clear the error code.
If the control unit is in Standby Mode, press the Start/Stop button to show the on-screen display. After
you have completed the troubleshooting solution steps, press any key (except the phone icon) to clear
the error code.
From the iAquaLink
™
App:
Press the error icon to display troubleshooting solutions. After you have completed the troubleshooting
solution steps, press Clear Error to return to normal operation. Or, press OK if you need to complete the
solution steps at a later time.
To Next Page
Loading...
Need help?
General
