7 - 13 BODY
BUCKET SEAT
DESCRIPTION
The driver and passenger front and middle seats in
the four and six passenger models are bucket
seats. Each seat assembly consists of a seat
cushion, built-in seat back and the seat is
adjustable. A handle under the front of the seat
cushion releases a latch, allowing the seat to move
forward or backward on two tracks, (front driver’s
seat only on 6-passenger models).
Fig. 7 Bucket Seat Adjuster
1 - Bucket seat
2 - Adjuster rails
3 - Adjusting lever
REMOVAL
4 PASSENGER
1. From beneath vehicle, remove nuts from the 4-
bucket seat anchoring bolts.
2. Remove the bucket seat assembly.
6 PASSENGER
1. For front bucket seats, see 4 passenger
procedure above.
2. For the middle row, from beneath vehicle
remove nuts from 3-bucket seat anchor ring
bolts.
3. Remove front battery access cover from middle
row bucket seat area.
4. Remove remaining bolts.
5. Remove three-point seat belt D-ring from
hanger of rear rail.
6. Remove the bucket seat assembly.
INSTALLATION
4 PASSENGER
1. Position bucket seat assembly over seat belt
bracket, aligning rear-mounting holes of seat
over mounting holes of seat belt bracket.
2. Insert the 4 mounting bolts through bucket seat
track, seat belt bracket into mounting holes in
raised front seat portion of floor panel.
3. From underneath vehicle, attach lock washers
and nuts to mounting bolts.
6 PASSENGER
1. For front bucket seats, see 4 passenger
procedure above.
2. Position bucket seat assembly over seat belt
bracket, aligning rear-mounting holes of seat
over mounting holes of seat belt bracket.
3. Insert the 3 mounting bolts through bucket seat
track, seat belt bracket into mounting holes in
raised front seat portion of floor panel.
4. Install the remaining bolt.
5. From underneath vehicle, attach lock washers
and nuts to mounting bolts.
6. Attach and install 3-point seat belt D-ring to
hanger of roof rail.
7. Install battery access cover.
GEM Service Manual November 2007
To Next Page
Loading...
Need help?
General
