22
FIRST USE INSTRUCTIONS
Adding Engine Oil
Failure to use the recommended 4-stroke engine oil may result in engine
damage, see page 64 for recommended oil and capacity.
1. Place the generator on a flat, level surface. Open the service door.
See page 46.
2. Remove the oil filler cap / dipstick
(A).
3. Fill the engine crankcase with the
specified amount (20.3 ounces / 0.6
liters) of engine oil.
4. Insert the dipstick in the filler hole and tighten the dipstick.
5. Remove the dipstick and verify
that the oil level is at the upper
limit (B). Add additional oil and
inspect the level as needed until
the upper limit has been
reached.
6. Re-install the dipstick (A). Use a clean shop rag to clean any spilled
oil.
7. Close the service door.
To Next Page
Loading...
Need help?
General
