31
OPERATION
Safe Operating Precautions
Starting the Engine
10. If connecting loads to generator, reference “AC Operation” or “DC
Operation” as outlined later in this Operation section.
11. Make sure to turn the AC switch to "ON"
position. Otherwise, there will be no AC
power output from AC receptacles.
Stopping the Engine
Continually stopping the generator with a load applied can lead to damage
of the control module.
In case of emergency, position the engine switch to OFF to stop the
engine. Under normal conditions, perform the following procedure.
1. Shut off or disconnect all appliances connected to the generator.
2. Position the ignition switch to OFF.
3. Shut off the fuel.
To Next Page
Loading...
Need help?
General
