Polaris P935 Owner's Manual

Page 6
English
3. Push base unit down (Figure 3) so the metal
handle frame is seated in the recess on the
underside of the base.
F igu r e 3 . C o nne c t M e t a l F r a m e t o B a se U nit
4. Slide the handnut over the tube and twist to
tighten onto base unit (Figure 4).
F igu r e 4 . T w ist H a nd nu t t o S e c u r e F r a m e
5. Snaptwo(2)supportblocksintoplace
(Figure5).
6. Slide axle and hubcap piece through center of
wheel and attach to base unit. Snap locking clip
into place to secure wheel. Repeat to attach both
wheels(Figure5).
F igu r e 5 . S na p in S u p p o r t B lo c k s a nd A t t a c h
W he e ls
7. Slide the control unit base / caddy handle
attachment down over the metal tubing until it
snaps into place. (See Figure 6).
F igu r e 6 . A t t a c h C a d d y H a nd le

Polaris P935 Specifications

General

Brand	Polaris
Model	P935
Category	Swimming Pool Vacuum
Language	English