Polaris PHOENIX Phoenix 200 User Manual

76
MAINTENANCE AND LUBRICATION
Spark Arrestor Clean-Out
WARNING
Do not perform clean-out immediately after the engine has been
run, as the exhaust system becomes very hot. Serious burns could
result from contact with the exhaust components.
Wear eye protection and gloves.
Never run the engine in an enclosed area. Exhaust contains
poisonous carbon monoxide gas.
Failure to heed these warnings could result in serious injury or
death.
Periodically clean the spark arrestor to
remove accumulated carbon.
1. Remove the three screws (1) and
remove the arrestor from the end of
the muffler.
2. Use a non-synthetic brush to clean
the arrestor screen. A synthetic
brush may melt if components are
warm. If necessary, blow debris
from the screen with compressed air.
3. Inspect the screen for wear and
damage. Replace if necessary.
4. Remove and inspect the gasket.
Replace if worn or damaged.
5. Reinstall the gasket and arrestor.
6. Torque screws to 50 in. lbs. (5.6 Nm).
1

Polaris PHOENIX Phoenix 200 Specifications

General

Brand	Polaris
Model	PHOENIX Phoenix 200
Category	Offroad Vehicle
Language	English

Summary

SAFETY

Operator Safety and Training Essentials

Key safety principles and training importance for ATV operators.

General Operation Safety Warnings

Critical safety practices for ATV operation, including instruction and gear.

Driving Environment Hazards

Safety precautions for operating in hills and through water.

Operator Behavior Hazards

Risks associated with improper instruction, age, and rider skills.

Riding Gear and Substance Use Warnings

Importance of protective gear and dangers of alcohol/drug use.

Speed, Stunts, and Inspection Hazards

Dangers of excessive speed, stunts, and neglecting pre-operation checks.

OPERATION

Break-In Period Procedures

Essential steps and precautions for the new vehicle's break-in period.

Pre-Ride Inspection Checklist

A comprehensive checklist for inspecting the vehicle before each use.

Starting the Engine

Step-by-step instructions for starting the ATV's engine.

Driving Procedures and Safety

Making Turns Safely

Techniques and warnings for making turns while driving the ATV.

Hauling Cargo and Towing Guidelines

Driving on Slippery Surfaces

Precautions for driving on slippery or loose surfaces.

Hill Driving Procedures and Safety

Guidelines for driving uphill safely, including weight shifts and speed.

Sidehilling Procedures

Safety precautions and techniques for sidehilling.

Driving Through Water

Driving Over Obstacles

Driving in Reverse

MAINTENANCE AND LUBRICATION

Periodic Maintenance Chart

Schedule for regular inspections, adjustments, and lubrication.

Lubrication Guide

Engine Oil and Filter Change

Transmission and Gearcase Oil Procedures

Spark Plugs Service

Vehicle Immersion Procedures

Brake System Adjustments

Toe Alignment Check

TROUBLESHOOTING

Engine Not Starting or Failing to Start

Possible causes and solutions for engine starting issues.

Engine Performance Issues

Engine Stops or Loses Power

Causes and solutions for the engine stopping or losing power.

WARRANTY

Limited Warranty Terms and Registration

Obtaining Warranty Service