PROBLEM POTENTIAL CAUSE CORRECTION
Abnormal vibration
Presence of debris in the system
Remove any debris that could prevent
proper operation of the system
Severe and localized wear on a wheel (flat
spot)
Replace part
Frozen sprocket or wheel
Remove ice/snow build-up. Storing the
vehicle at temperatures higher than 0°C
might be required. An optional Sprocket
Scraper kit is available. Contact Customer
Service.
Beginning of derailing
Check tensioner alignment. Make sure that
the track is well guided by the wheels and
track guide. Realign Track System if needed.
Check wear on wheels, track guide and track
drive lugs
Presence of dirt between wheel hub and
track system hub could cause incorrect
seating of mating surfaces when installing
track system
Remove system and clean contact surfaces
between hubs
Damaged Hub or wheel bearing Replace damaged bearing
Wheel Hub or track system hub deformed
following an impact or abusive use
Replace deformed part
Unstable behavior
Incorrect adjustment of angle of attack
Adjust angle of attack according to
manufacturer's specifications. (Refer to
Adjustments section in User Manual)
Track tension too high
Adjust track tension. (Refer to Adjustments
section in User Manual)
Misalignment of Track System
Correct alignment. (Refer to Adjustments
section in User Manual)
To Next Page
Loading...
Need help?
General
