5
❷ Installa on
2.1 I Preparing the pool
• For op mal opera on, the pool water must meet the following condi ons:
Water temperature Between 15°C and 35°C
pH Between 6.8 and 7.6
Chlorine < 3 mg/ l
• Stop the fi ltra on pump, allow to prime.
• Start the booster pump. Bleed the water circuit for 5 minutes.
• Stop the fi lter pump and booster pump.
• When the pool is dirty, especially when fi rst installing the cleaner, remove the largest debris using a manual brush
and a net.
• Remove any thermometers, toys and other objects that might damage the appliance.
Tip: To maintain the cleaner in good condi on
A er cleaning or backwashing, run the fi ltra on system for at least fi ve minutes before reconnec ng the
cleaner.
2.2 I Installa on principle
: The water is sucked by the
pump via the skimmers and fl oor
drain.
: The water is sent to the fi lter to
be cleaned.
: The clean water is discharged
into the pool return lines.
: A devia on is created on this
piping to supply the booster pump.
: Polaris® pressure cleaners
are connected to the wall fi ng
transformed into a discharge port
: The venturi eff ect generated
by the jets transforms the water
supply into a powerful suc on
current and allows the cleaner to
move.
EN
To Next Page
Loading...
Need help?
General
