5. Include the weight of a rider on the seat while performing this step. Observe
the headlight aim. As a starting point, the most intense part of the headlight
beam should be 2 inches (5 cm) below the mark on the wall. Adjust to
operator preference.
6. Tighten or loosen the three (3) headlight screws
q
on the rear of the
headlight to adjust the beam upward or downward or to the left or right.
VEHICLE IMMERSION
NOTICE
If your vehicle becomes immersed, major engine damage can result if the
machine is not thoroughly inspected. Take the vehicle in for service before
starting the engine. Your POLARIS dealer or other qualified person can
provide this service.
If it’s impossible to take your vehicle to a dealer before starting it, follow the
steps outlined below.
1. Move the vehicle to dry land.
2. Check the air box. If water is present, dry the air box and replace the filter
with a new filter.
3. Remove the fuse/relay center cover. Allow any moisture to dry, then reinstall
the cover.
4. Dry the spark plug wells with a clean cloth, then remove the spark plugs.
5. Turn the engine over several times.
6. Dry the spark plugs and reinstall them, or install new plugs.
7. Attempt to start the engine. If necessary, repeat the drying procedure.
148
MAINTENANCE
To Next Page
Loading...
Need help?
General
