TRANSPORTING THE VEHICLE
NOTE
For functional descriptions detailing how to operate the DYNAMIX suspension
system, consult the DYNAMIX Active Suspension chapter in this manual.
Follow these procedures when transporting the vehicle.
NOTICE
After a ride, allow the engine to idle for 30 seconds before stopping the engine.
This will allow the turbo system to cool down.
1. Place the transmission in PARK.
2. Stop the engine. Turn the key back on to the accessory or ON position
without starting the engine. Slowly release the brake pedal and make sure
the transmission is in PARK before exiting the vehicle, verifying that the
PARK position is shown on the display.
3. Prior to securing the vehicle, adjust the vehicle’s compression damping
settings to their lowest (softest) setting by turning the clickers all the way out.
On vehicles equipped with DYNAMIX active suspension, the key switch must
remain in the ON position, the suspension mode switch must be in the
COMFORT setting, and the demo mode timeout must not be active while
securing the vehicle. Shock damping settings can be verified on the
Suspension visualization screen.
158
MAINTENANCE
To Next Page
Loading...
Need help?
General
