IGNITION SWITCH
The ignition switch is a four-position, key-operated switch. Use the ignition
switch to start the engine. See page 62 for starting procedures.
POSITION FUNCTION
OFF
The engine is off. Electrical circuits are off, except
accessory 12V.
ACCESSORY
The engine is off. Powers the gauge and terminal
block. Check engine and power steering warning
indicators will appear on the gauge in this mode but will
turn off when the vehicle is started if no issues are
present.
ON
Electrical circuits are on. Electrical equipment can be
used.
START
Turn the key to the START position to engage the
electric starter. The key returns to the ON position
when released.
The key can be removed from the switch when it is in the OFF position.
HEADLIGHT SWITCH
Use the headlight switch to turn the lights on and off and to change the lights
from high beam to low beam. The ignition switch must be in the ON position to
operate the headlights.
Press the top of the rocker switch toward the dash to place the headlights on
high beam
q
. Move the rocker switch to the center position to place the
headlights on low beam
w
. Press the bottom of the rocker switch to turn off the
headlights.
If the headlight switch is ON when the ignition switch is turned off, the lights will
remain on for approximately 30 seconds.
35
FEATURES AND CONTROLS
To Next Page
Loading...
Need help?
General
