27
FEATURES AND CONTROLS
Switches
Headlight Switch
Use the headlight switch to turn the lights on and
off and to change the lights from high beam to
low beam. The ignition switch must be in the ON
position to operate the headlights.
Press the top of the rocker switch for high beam.
Move the rocker switch to the center position for
low beam. Press the bottom of the rocker switch
to turn headlights off.
If the headlight switch is ON when the ignition switch is turned off, the
lights will remain on for approximately 30 seconds.
All Wheel Drive (AWD) Switch
Press the top of the rocker switch to engage
All Wheel Drive. Press the bottom of the
switch to operate in two wheel drive. See
page 38 for AWD operating instructions.
Winch Switch
Press the top of the rocker switch to spool line
out from the winch. Press the bottom of the
rocker switch to spool line in to the winch.
Move the rocker switch to the center position
to stop spooling.
Remote Winch Switch
Pull the remote winch switch
and cable out from the dash
storage area. Press and hold the
left side of the switch to spool
line out from the winch. Press
and hold the right side of the
switch to spool line in to the
winch. Release the switch and it
returns to the center “OFF”
position to stop spooling.
HIGH
LOW
OFF
AWD
2WD
OUT
IN
OFF
OUT
IN
OFF
To Next Page
Loading...
Need help?
General
