75
MAINTENANCE
Lubrication
EDGE 136 Rear Suspension
Driveshaft Bearing
Inject grease into the fitting on the speed-
ometer sensor housing until grease purges
from the seal on the inside of the tunnel.
This should take approximately two
pumps. Do not use more than four pumps.
Throttle Cable
Lubricate the throttle cable lightly
with grease or oil. With the engine off,
turn the handlebars to the left and
lubricate liberally as shown.
Choke and Choke Cable
Lubricate the choke slide and cables
lightly with oil or grease. Before
turning the engine off, operate the
choke intermittently to draw mois-
ture out of the choke plunger area
and reduce the possibility of the
choke becoming frozen.
To Next Page
Loading...
Need help?
General
