80
MAINTENANCE AND LUBRICATION
Adjustments
Steering Assembly
The steering assembly of the ATV should be checked periodically for
loose nuts and bolts. If loose nuts and bolts are found, see your Polaris
dealer for service before operating t he vehicl e.
Camb er an d Caster
The camber and caster are non-adjustable.
Rear Spring
The rear shock absorber spring is
adjusted by rotating t he adjuster (1)
either clockwise or counterclockwise to
increase or decrease spring tension.
NOTE: Accessory springs are available
through your Polaris dealer.
Handlebars
The handlebars can be adjusted for
rider preference.
1. Remove the handlebar cover
and locate the handlebar bolts (1).
2. Loosen the four bolts.
3. Adjust the handlebar to the
desired height. Be sure t he
handlebars do not contact the
gas tank or any other part of the
machine when turned fully to the left or right.
4. Torque the front two bolts to 10-12 ft. l bs. (14-17 Nm), then
torque the rear two bolts. A gap of up to 1/8” will remain at the
rear bolts.
1
Improper adjustment of the handlebars or incorrect torquing of
the adjuster block tightening bolts can cause limited steering or
loosening of the handlebars, resulting in loss of control and
possible serious personal injury or death. Follow the adjustment
procedures exactly, or see your Polaris dealer for service.
WARNING
1
To Next Page
Loading...
Need help?
General
