9 Troubleshooting Problems
• Troubleshooting
The troubleshooting guide is designed to help you. If problems
continue, please contact your local customer support hot line. See your
registration card for help line contact details.
For Windows® Users:
PC
Symptom Problem Solution
I receive an error message
when I am installing
“Polaroid PDC 2350 Camera
Driver”.
“Polaroid PDC 2350 Camera
Driver” does not load.
Shut down all other applications and attempt
to reinstall the driver.
Check to see if the USB controller in your
BIOS if it is activated. If this does not work
contact your national customer support
representative, refer to the instruction manual
included with your PC.
I cannot upload images to my
computer.
Connection failure.
Check all cable connections are secured.
I cannot run the “Polaroid
PDC 2350 Camera Driver”.
Conict with another camera
driver or capture device.
If you have another camera installed on your
computer, remove it and it’s driver completely
from your system to avoid conicting with
your PDC 2350.
I see the following error
message during driver
installation. “An error
occurred during the
move data process: -115
Component:\WIN98\ICO File
Group: 98ICO File: C:”
Polaroid PDC 2350 driver installs
second time.
Please remove the existing PDC 2350 driver
rst and install again. (For Windows 98SE
only)
Camera Driver is not installed. You need to install the camera driver for
Windows 98SE systems.
Images do not show on TV.
Video cable is not connected
correctly.
Wrong system selection
Images do not display in
colour.
Make sure the video cable is connected to the
TV “Video In” socket.
Change to NTSC for USA.
My CD Installation wizard
does not work.
The auto installation le is
switched off or The CD-ROM is
disconnected.
Go to the computer desktop. Right click on “My
Computer”. Click “Properties”. Select “Device
Manager”. Double click on “CD_ROM”, double
click on “CD-R (normally the manufacturer’s
name. Click on “Settings”. Ensure both “Auto
insert notication” and the “disconnect” are
ticked. If you change the settings the computer
will ask you to restart your PC. Click “Yes”.
(For Windows 98SE only)