To disconnect computer communication, press "BACK" – the dosimeter will go into the
DER measurement mode. To connect computer communication, enter the "SETTINGS" and select
"USB".
When upon the connection of USB cable to the dosimeter the communication with computer
isn’t established automatically go into “SETTINGS”, select line USB and shortly press “SELECT”.
After audio signal the dosimeter goes into communication with computer.
For a safe exit from communication with computer press “BACK” − the dosimeter goes into
the DER measurement mode, only afterwards connect the USB cable off the dosimeter.
2.2.8.2 The following functions can be performed in the mode of communication with
computer using the user software:
- read information (history) from the dosimeter’s memory;
- write setup parameters into the dosimeter;
- process information read from the memory.
For detailed description of the user software please refer to the Help file.
2.2.8.3 Instrument РМ1610В-01 transfers information to the external reading device by the
radio-channel according to ISO 15693.
Do the following to enable instrument-PC radio channel communication:
- install user software (supplied on the CD) onto the PC;
- connect a reading device to the PC USB-port (use a cable);
- start user software.
Reading procedure:
- press any key on the instrument;
- place the instrument’s back surface close to the center of the reading device;
- the reading device will produce sound and light a red LED if the information exchange is
successful.
The instrument registration dialogue window will appear at the first reading. Register the in-
strument as required.
During next readings a message displaying the instrument number and current accumulated
dose value will be shown. The instrument serial number, current dose and dose rate values will be
automatically sent into the software database simultaneously.
2.2.9 Low Battery Indication and LCD Backlight
In any operating mode dosimeter continuously monitors battery voltage. The battery symbol
is displayed on the left upper side of the screen. Completely filled symbol indicates nominal battery
voltage. The filled portion of the battery symbol decreases as the battery voltage drops. When the
battery voltage drops to its minimum, the battery symbol is empty. In case of critical battery
discharge, dosimeter produces sound and light warning signals and indicates "REPLACE THE
BATTERY" message and then switches the LCD indication off. In this case battery must be
replaced (2.1.3.3).
To activate indication on the LCD press any button.
After battery replacement it is necessary to set the internal clock of the dosimeter.
To Next Page
Loading...
Need help?
General
