Polycom CX300 R2 User Manual

Polycom CX300 R2 Desktop Phone User Guide
Polycom, Inc. 15
To place a call on hold:
» Do one of the following:
 If you are in an active call, press the Flash button to place the call on hold.
 If you receive an incoming call while you are in an active call, press the Flash button to place the
active call on hold and answer the incoming call.
 If you are in a call and you have another call on hold, press the Flash button to place the active
call on hold and resume the call that is on hold.
To resume a held call:
» Do one of the following:
 If you have a call on hold, press the Flash button to resume the call.
 If there are several calls on hold, press the Flash button to cycle through the held calls.
Listen to Voicemail Messages
The voicemail feature is configured by your system administrator, who assigns you a PIN to access your
voicemail. You can access your voicemail on your phone by pressing and holding the 1 key on the keypad.
If the phone does not connect to the voicemail after you press and hold the 1 key, you do not have any new
messages.
To listen to voicemail messages:
1 Press and hold the 1 key on the keypad for 1.5 seconds.
2 When prompted, enter your PIN.
Your voicemail messages play.
Restart Your Phone
On rare occasions, your phone may experience a problem that will require you to restart the phone. Contact
your system administrator before restarting your phone.
To restart the phone:
» Unplug the phone from the computer, wait one second, and plug the phone into the computer.
The phone restarts.

Polycom CX300 R2 Specifications

General

Brand	Polycom
Model	CX300 R2
Category	Telephone
Language	English