Polycom® RealPresence® Group Series Media Center Setup Sheet
2
1
Remove the base from packaging and flip the base over.
Attach the four legs to the base, using two M10 x 50
flanged socket head cap screws per leg.
Polycom
®
RealPresence
®
Group Series Media Center
with a Single 55”, 65”, or 84“ Display or 55” Dual Displays
3
Detach the pre-installed speaker bracket from each
vertical support by removing the 1/4-20 x 5/8 socket head
cap screws, flat washers, and lock washers. Set them
aside.
2
4
Install the supplied floor glides on the legs, using one flat
washer and one split lock washer per glide. Ensure that the
flat washer is closest to the leg surface. Alternatively,
install the optional casters on the legs. The locking casters
must be installed on the front legs, which are located on the
side of the base with no slots. Attach the casters using one
flat washer and one lock washer per caster. Ensure that the
flat washer is closest to the leg surface. Pull the caster
up to fit the wrench underneath to tighten the hardware.
After tightening, push the caster back down.
With the assistance of another person, flip the base over
and lock the front casters.
Place the left vertical support on the base, aligning the
holes in the base with the holes in the bottom of the
vertical support. Attach the vertical support to the base
using three M10 x 25 flanged socket head cap screws per
vertical support. Do not fully tighten. Repeat with the
right vertical support.
Front Side with
Locking Casters
Use the optional casters only with dual 42”, single
or dual 55”, or single 65” display configurations. Do
not use the optional casters with dual 65” or single
84” display configurations. This violates safety
standards and could cause serious injury or death.
Note: For the RealPresence Group Series wall-secured option, refer to the Polycom RealPresence Group Series Wall-Secured
Setup Sheet.
To Next Page
Loading...
Need help?
General
