19
3. Remove any shipping tape from your label stock roll to ensure that it can unroll
freely, making certain that no adhesive portion is exposed. It is important to note
that any exposed adhesive surface can attach itself to the inner workings of the
print mechanism and cause a media jam.
4. Place your roll of label stock on the Roll Arm and push it inward until it touches the
Roll Stop.
5. Flip up the Roll Guide and slide it inward until it touches the label stock. The Roll
Guide will automatically pull back slightly to the correct position. There should be
approximately a 1mm gap between the Roll Guide and the roll.
Important Note: Be aware that some label stock may have a core that is slightly too large
for the roll or the labels may have wrapped unevenly, causing some to stick out
beyond the edge of the core. Both of these issues can cause feeding problems.
6. Pull the Movable Throat Guide outward to make room for the label stock.
7. Place the leading edge of the label stock under the "label stock" symbols on the
Throat Guides. The label stock should be placed far enough into the throat of the
Printer to correctly position the Movable Throat Guide but not yet into the Printer
itself
To Next Page
Loading...
Need help?
General
