21
Circular Labels
If you are using Circular Labels, you must adjust the stock sensor to correspond with
the very top of the label where the circles are closest together. If the sensor is too far
to the right or the left, the Printer will still sense the label, but the image may be offset
downward because the Printer will start printing at the wrong position. If you are using
stock that has multiple labels across, make sure the sensor corresponds to a place on
the stock that has a label and not a vertical gap.
The sensor can only be moved a maximum of 2 inches from the left side of the
printable area. This means that the maximum diameter circular label that can be
printed is 4 inches. For circular labels larger than 4 inches in diameter, you must have
a black mark printed on the back of the label stock.
This means that you must change the Stock Sensor Mode to Reflective. The Printer will
now look for the black mark representing the beginning of the next label instead of the
die-cut. For more information on changing the Stock Sensor Mode see Section 2D.
To Next Page
Loading...
Need help?
General
