25
Cut after label count. This option will cut after the number of labels specified in the
toggle box that appears when this option is selected. This is useful if you have
front/back labels or sets of labels.
Cut after no activity. This setting will cut at the end of a print job if the Printer does not
receive another print job within one second of the last print job in the queue. You can
usethis feature to cut at the end of multi-copy job, multi-page job or multiple individual
jobs in the queue.
Cut every label. This setting will cut after every label.
Present Timer. Adjust this value to control how long after the last print the Printer will
present the label for cutting or tear off. This can be useful to prevent unwanted cuts
between jobs in queue.
Present Options:
Uncheck the Cutter Enabled box to show present options.
Do not present. In this mode the label stock does not move after the last label is
printed. This means that part of the last label printed is still in the Printer. This should
be used only if you have a label rewinder attached.
Present after no activity. This setting will present (feed all printed labels past the tear
off point) at the end of a print job if the Printer does not receive another print job
within one second of the last print job in the queue. You can use this feature to present
at the end of a multi-copy job, a multi-page job or multiple individual jobs in the queue.
To Next Page
Need help?
General
