49
looking for a gap too late. This can cause label skipping or inconsistent print starting
points. Adjust the page size in the printer driver settings.
5. Portrait / Landscape. If the Portrait / Landscape setting does not correspond to the
label stock installed this will also cause the Printer to print over the gap and onto
the next label. Make sure this is set correctly.
6. Stock Sensor Position. Circular, nonstandard label shapes or multiple labels across
will require precise adjustment of the label sensor. If you are using circular or other
non rectangular die-cut labels see Section 2C for instructions.
The image is printing horizontally offset.
1. Label Stock Loading. It is very important to correctly load the label stock so that there is
no space between the throat guides and the label liner edge. If there is a gap between the
throat guides and the label stock it may "walk" back and forth causing inconsistent
horizontal printing. See section 2B for label stock loading instructions and tips.
2. Left Margin Offset. This adjustment is found on the Alignment tab of the PrintHub. See
Section 4D.
3. Page Size. Often the page size is not large enough for the label. If this is the case you
may see white space on the right (Printer's left) side of the the label and no image over-
lap on the opposite side. This indicates that the page size needs to be increased. Increase
the page size through the printer preferences enough to cover the label.
To Next Page
Loading...
Need help?
General
