6
2. If there are shipping brackets (not shown) on the
rear of the Frame (1), remove the screws from
the shipping brackets and discard the screws
and the shipping brackets.
Identify the Rear Stabilizer (3), which has a
Leveling Foot (28) near each end.
Set a sturdy piece of packing material (not
shown) under the rear of the Frame (1).
Orient the Rear Stabilizer (3) as indicated by the
sticker. Attach the Rear Stabilizer to the Frame
(1) with two M10 x 68mm Screws (44).
Then, remove the packing material.
44
28
28
3
1
2
ASSEMBLY
• Assembly requires two persons.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until you nish all assembly steps.
• Left parts are marked “L” or “Left” and right parts
are marked “R” or “Right.”
• To identify small parts, see page 5.
In addition to the included tool(s), assembly
requires the following tools:
one Phillips screwdriver
one adjustable wrench
Assembly may be easier if you have a set of
wrenches. To avoid damaging parts, do not use
power tools.
1
1. To register your product and activate your
warranty in the UK, go to iconsupport.eu. If
you do not have internet access, call Customer
Service (see the front cover of this manual).
To register your product and activate your
warranty in Australia, email or post the
following information to the email address or
postal address on the front cover of this manual.
• your receipt (make sure to keep a copy)
• your name, address, and telephone number
• the model number, serial number, and name
of your product (see the front cover of this
manual)
To Next Page
Loading...
Need help?
General
