ProBreeze PB AC04 User Manual

Compressor Delay Protection
To protect the compressor, apart from when
the appliance and compressor are activated for
the first time after being turned on via the
power button, there will be a three minute delay
between every occurrence of the compressor
turning off and on.
Safety Features
Helpful Information
15 | English
Issue Cause
No power.
Water tank full.
Room temperature too low.
Air inlet or air outlet clogged.
There is direct sunlight.
Too far from appliance.
The remote control is not pointing towards
the receiving head of the remote control
The batteries are dead.
Pipe temperature sensor failure.
Room temperature sensor failure.
Anti-frost protection.
Noisey.
The compressor does not
work.
The remote control does
not work.
Display showing E1.
Display showing E2.
Display showing E4.
Drain the water stored in the unit.
Wait three minutes until the temperature
decreases and then turn on the unit..
Bring the remote control closer to the
appliance and ensure that the remote
control is pointing toward the receiving
head of the remote control.
Resolution
The appliance
is not operating.
Connect the unit to a live
power socket and turn it on.
It is recommended that this
unit be operated at 5-32°C.
Increase the set temperature
above the room temperature.
Clean filters.
Draw curtains.
Room temperature lower than the
set temperature cooling mode.
Dirty filters.
Remove the obstruction.
Poor cooling.
Close doors and windows and
remove other heat sources.
Doors and windows are open or
there are other heat sources.

ProBreeze PB AC04 Specifications

General

Brand	ProBreeze
Model	PB AC04
Category	Air Conditioner
Language	English