Starting the Engine; Engine Idle
1. After synchronizing and calibrating the drone, move the throttle and
direction sticks to the lower left and lower right corners (blue lines)
and release to go into Idle mode. The blades will rotate but the drone will
not lift.
Take – O:
1. Press the take o button. The remote will beep and the drone will hover
a few feet o the ground. Then gently advance the throttle to a desired
height and release. The drone will hover at that height.*
OR
2. From Idle mode, gently advance the throttle up to a desired height and
release. The drone will hover at that height.*
Landing:
1. Press the landing button to lower the drone to the ground.
OR
2. Push down on the throttle until the drone is on the ground.
NOTE:
- The engine will shut o if you choose to hold the throttle down for 3
seconds.
- Emergency Shut O: When in ight,
pull the throttle and direction stick to
the center at the same time (red lines)
and the drone will shut o.
- The drone may drift a bit, especially in the rst 30 seconds until the
altitude sensor gets a good x on the position. Some drift is normal.
* Press down once to calibrate. Lights will ash quickly during calibration
and then go steady when completed. Don’t worry if you press it again as
it will simply recalibrate again.
To Next Page
Loading...
Need help?
General
