Pullman M7P User Manual

CLEANING AND MAINTENANCE
DANGER: Before performing any
maintenance operations, unplug the
appliance from the electrical socket.
DAILY CLEANING
Emptying the recovery tank
- Disconnect the detergent delivery hose (4 Fig.3)
and the flexible hose (1 Fig.2).
- Disconnect the detergent suction hose (6 Fig.4).
- Lift up the levers (35 Fig.18) and remove the
cover (36 Fig. 19) complete with motor.
- Remove the detergent container (21 Fig.20)
lifting it by the handles.
- Place yourself over a floor drain and empty the
liquid in the recovery tank (37 Fig.21)
- Clean the inside of the tank with running water
and then reassemble everything proceeding in
the reverse order.
Cleaning the detergent dosing circuit
At the end of each workday, clean the detergent
dosing circuit as follows to prevent clogging:
- Disconnect the detergent delivery hose (4
Fig.3).
- Disconnect the detergent suction hose (6 Fig.4).
- Lift up the levers (35 Fig.18) and remove the
cover (36 Fig. 19) complete with motor.
- Remove the detergent container (21 Fig.20)
lifting it by the handles.
- Remove the cap (20 Fig.10) of the detergent
container and empty the residual liquid into a
suitable container.
- Wash the inside of the detergent container with
running water.
- Reassemble all of the parts performing these
operations in the reverse order.
- Pour clean water into the detergent container,
electrically connect the appliance and start the
dosing pump by pressing the switch (25 Fig.13).
- Clean the circuit by pressing the switch (28
Fig.15) or the lever (32 Fig.15), depending on the
type of nozzle.
- Dispense the liquid from the nozzle until clean
water comes out.
- Empty the water in the detergent tank as
described above.
Cleaning the appliance body
- Clean the unit body with a cloth dampened with
water or a mild detergent;
DANGER: Do not wash the appliance using
jets of water.
PERIODIC CHECKS
Checking the air outlet filter
- Loosen the screws (38 Fig.22) and remove the
cover (39 Fig.22)
- Remove the filter sponge (40 Fig.23) and clean
it with a blast of air (Fig.24). The filter sponge
can be washed in warm water and must only
be replaced once it is completely dry. If it is too
dirty, replace it with a new one.
- Reassemble all the parts by following the
dismantling process steps in the reverse order.
Cleaning the detergent dispensing
nozzle
If you note that the detergent is not dispensed
evenly, clean the nozzle as described below:
- Remove the ring nut (37 Fig.25).
- Remove the nozzle (38 Fig.25) and clean it with
running water, if it is clogged use a pin being
careful not to distort the shape of the nozzle.
- Reassemble all of the parts performing these
operations in the reverse order.
11PULLMAN M7 SPRAY EXTRACTOR

Pullman M7P Specifications

General

Brand	Pullman
Model	M7P
Category	Ventilation Hood
Language	English