1. Do not operate the vacuum cleaner too close to heaters, radiators, and other
hot surfaces.
2. Before inserting the plug into the wall, make sure your hand is dry.
3. Before turning on the vacuum cleaner, remove any large or sharp objects from
the floor or cleaning surface in order to prevent damage to the filter.
4. When you want to pull the plug from the wall, do not use the power cable, gently
pull the plug from the power socket.
5. If the hose inlet or telescopic tube are blocked, you should switch off the cleaner
straight away and remove from mains power. Clear the blockage before attempting
to start the vacuum cleaner again.
BEFORE YOU BEGIN
This machine is equipped with a cord and plug. In the event that either of these parts get
damaged, it must be repaired by a qualified technician.
Warning:
For your safety, disconnect the cleaner from the power supply before you refill the water tank,
empty the bin or change the accessories.
FAULTS
Consult the trouble shooting guide in this manual if your carpet washer fails to operate properly.
Do not continue to use this appliance if it appears to be faulty or the supply cord is damaged. If a fault can’t
be rectified, please return to the point of purchase.
CAUTION!
The cover (Part 36 in Fig.19) head contains electrical connections. It is not a serviceable part. Please return
the product to your nearest Godfreys store if it is faulty.
Do not wash the cover with water or immerse the top cover water.
3PULLMAN M7 SPRAY EXTRACTOR
To Next Page
Loading...
Need help?
General