Pullman M7P User Manual

USING THE APPLIANCE
- The appliance is fitted with wheels and can
therefore be pulled along using the flexible
hose.
- To lift it up, insert your fingers under the handle
(22 Fig. 11) on the top of the cover.
Starting up the appliance
- Insert the plug (23 Fig.12) into the electrical
socket.
- Push the switch (24 Fig.13) on “I” to start the
suction motor; the switch lights up.
- Push the switch (25 Fig.13) on “I” to start the
detergent pump; the switch lights up.
NOTE: The suction motor and the
detergent pump operate independently;
therefore, it is possible to:
- wash fabrics or floors/ carpets by
starting only the detergent pump;
- wash and suction liquid simultaneously
by starting up the detergent pump and
suction motor at the same time;
- suction liquids by only starting the
suction motor.
NOTE: For the ergonomic handle (if
present) it is possible to adjust the suction
force using the selector (26 Fig.14). The
suction force is decreased by opening the
window (27 Fig.14).
Washing floors or carpets
- To wash floors or carpets it is necessary to
mount the hose with ergonomic handle (9
Fig.15), the rigid extensions (10 and 11 Fig.15)
and the floor nozzle (13 Fig.15), if present.
- Start the suction motor and the detergent
pump by pressing the relative switches (24 - 25
Fig.13).
- Press the switch (28 Fig.15) to dispense
the detergent, release the button to stop
dispensing. The switch (28 Fig.15) can be
blocked in the pushed position (continuous
detergent dispensing) by moving the slide (29
Fig.15) towards the switch (28 Fig.15). When the
slide (29 Fig.15) is moved back to its original
position the switch is released and detergent
dispensing stops.
- The detergent released washes the floor/
carpet / and the dirty liquid is suctioned into the
tank of the appliance. For very dirty areas it is
recommended you apply detergent to the dirty
area without suctioning it; leave the detergent
allowing it to work for several seconds and then
wash the area and suction the dirt.
NOTE: To prevent the detergent pump
from breaking, it is recommended that you
stop its operation, pushing the relative
switch, when dosing has not occurred for
several minutes
NOTE: When the recovery tank is full,
noise increases and the appliance does
not suction; therefore, switch it off and
empty the tank as described in the
relevant paragraphs.
Cleaning chairs
- Mount the fabric nozzle (30 Fig.16) on the
relative hose (31 Fig.16).
- Start the suction motor and the detergent
pump by pressing the relative switches (24 - 25
Fig.13).
- Place the nozzle on the fabric pressing slightly
then press the switch (28 Fig.15) or the lever
(32 Fig.15), depending on the nozzle type,
to dispense the detergent, release to stop
dispensing.
For very dirty areas it is recommended you
apply detergent to the dirty area without
suctioning it; leave the detergent allowing it to
work for several seconds and then wash the
area and suction the dirt.
9PULLMAN M7 SPRAY EXTRACTOR

Pullman M7P Specifications

General

Brand	Pullman
Model	M7P
Category	Ventilation Hood
Language	English