31
English
30
English
WARNING
● Do not remove the battery from the watch.
● If it is necessary to take out the battery, keep it out of the reach of
children. If a child swallows it, consult a doctor immediately.
● Never short-circuit, tamper with or heat the battery, and never expose
it to fire. The battery may burst, become very hot or catch fire.
CAUTION
● The battery is not rechargeable. Never attempt to recharge it, as this
may cause battery leakage or damage to the battery.
● Necessary procedure after battery change
After the battery is replaced with a new one, or when an abnormal display (failing digits,
etc.) appears, follow the procedures below to reset the built-in IC. The watch will resume
its normal operation.
Press and hold buttons A, B, C and D at the same time for 2 to 3 seconds until the
display becomes blank, then release all the buttons. The watch returns to its
default setting, which is “12:00'00" a.m., Jan. 1st, 2005, SAT” with “UTC” selected
as "Home City" and contrast level 5. Before start using the watch, set the time,
calendar including "Home City", and alarm.
BATTERY CHANGE
2
Years
Battery life : Approx. 2 years
Battery : SEIKO SR626SW, 1 piece
(for analogue display)
SEIKO SR41W, 1 piece
(for digital display)
● The battery life may be less than 2 years if the alarm is used for more than 10
seconds a day and/or the illuminating light more than once (for 3 seconds) a day.
● Even if either of the two batteries has run down, replace both of them with
new ones.
● As the batteries are inserted at the factory to check the function and performance
of the watch, their actual lives once in your possession may be less than the
specified period.
● When the batteries expire, be sure to replace them as soon as possible to prevent
any malfunction.
● We recommend that you contact an AUTHORIZED PULSAR DEALER for battery
replacement.
To Next Page
Loading...
Need help?
General
