35
English
34
English
If your watch has a
protective film and/or a
sticker on the case back,
be sure to peel them off
before using your watch.
PRECAUTION REGARDING
CASE BACK PROTECTIVE FILM
Be careful not to expose
the watch to solvents,
mercury, cosmetic spray,
detergents, adhesives or
paints. Otherwise, the
case, bracelet, etc. may become
discolored, deteriorated or damaged.
CHEMICALS
The IC (Integrated Circuit)
used in your watch will be
affected by static electricity
which may disturb the
display. Keep the watch
STATIC ELECTRICITY
away from close contact with objects
such as TV screens which emit strong
static electricity.
Light activities will not
affect your watch, but be
careful not to drop your
watch or hit it against hard
surfaces, as this may
cause damage.
SHOCKS & VIBRATION
It is recommended that the
watch be checked once
every 2 to 3 years. Have
your watch checked by an
AUTHORIZED PULSAR
DEALER or SERVICE CENTER to
ensure that the case, crown, buttons,
gasket and crystal seal remain intact.
2 - 3
Years
PERIODIC CHECK
N
S
MAGNETISM
The analogue unit of your
watch will be adversely
affected by strong
magnetism, though the
digital unit will not be
affected. Keep the watch away from
close contact with magnetic objects.
To prevent possible rusting
of the case and bracelet
caused by dust, moisture
and perspiration, wipe
them periodically with a
soft dry cloth.
CARE OF CASE AND BRACELET
To Next Page
Loading...
Need help?
General
