Q'STRAINT QRT-1 Series Use And Care Manual

19
TROUBLESHOOTING
PROBLEM IMAGE ANSWER
The webbing is twisted inside
the retractor.
Press and hold Red Release Lever then pull
J-Hook until webbing is straight.
The retractor(s) is (are) not
releasing the webbing.
Press and hold Red Release Lever to release
webbing from retractor.
It’s an Emergency and the
retractor(s) is (are) not releasing
the webbing.
Press and hold Red Release Lever then pull
J-Hook—if retractor(s) is (are) not releasing the
webbing(s), cut webbing(s) at an angle.
The retractor(s) is (are)
not working.
Call a Q’Straint® authorized dealer.
The webbing is slacking.
Retractors: Move wheelchair forward and back
to remove slack from webbing and self-tension,
or manually tensions webbing with retractor
knobs.
Manual Tiedowns: Pull end of webbing loop to
tension the webbing

Q'STRAINT QRT-1 Series Specifications

General

Brand	Q'STRAINT
Model	QRT-1 Series
Category	Wheelchair
Language	English