16 Installing and Configuring the SKM VMware Servers
Quantum Scalar Key Manager 2.5 Quick Start Guide
Figure 8 SKM Admin
Commands
20 At the Command prompt, type q and press <Enter> to quit, save your changes,
and restart the SKM key server. This process takes a few seconds.
Note: You MUST quit at this point. Otherwise your changes will not be saved and
you will not be able to continue the installation process.
21 Complete steps 1-20 on the secondary SKM node before proceeding.
22 When you are finished, do one of the following:
• For pre-SKM 2.4 (240Q) systems, proceed to Installing TLS Certificates on the
SKM Server for Pre-SKM 2.4 (240Q) on page 25.
• For SKM 2.4 (240Q) and later systems, proceed to Installing TLS Certificates on
the SKM Server for SKM 2.4 (240Q) or Later on page 28.
Caution: Do NOT power on the VM instance yet. Wait until you configure the
MAC ID per the instructions below. Otherwise, you will have problems
with the MAC address later.
To Next Page
Loading...
Need help?
General