Quantum Scalar i80 Quick Start Guide

Installing and Configuring the SKM VMware Servers 13
Scalar Key Manager 2.5
Figure 6 Video Card Settings
5 Power ON the SKM VM server (right-click the SKM VM server in the left panel, select
Power, then select Power On).
6 Highlight the SKM VM server in the left panel.
7 In the right panel, click the Console tab. Wait a few moments for the software to
load.
Note: When using the console, you will lose the ability to use your mouse/cursor.
To regain the use of the mouse/cursor, press <Ctrl+Alt>.
Note: If you receive the following error message when trying to use the console,
follow the workaround steps listed below.

Error message: This kernel requires an x86-64 CPU, but only detected an
xxxx
CPU. Unable to boot - please use a kernel appropriate for your CPU.
Workaround: First be sure that you are indeed using a 64-bit host server. If
so, change the host BIOS processor settings as follows, then follow the
onscreen instructions:

- 64-bit: Yes
- Virtual Technology: Enable
- Execute Disable: Disable

Quantum Scalar i80 Specifications

General

Power supply type	AC
Power requirements	100 – 240V, 50/60Hz
Power consumption (typical)	200 W
Dimensions (WxDxH)	445 x 793 x 264 mm
Media types supported	2x LTO-4
Maximum supported storage capacity	128 TB
Storage temperature (T-T)	-40 - 60 °C
Operating temperature (T-T)	10 - 35 °C
Operating relative humidity (H-H)	20 - 80 %
Media type	Tape Cartridge
Form factor	6U
Product type	Storage auto loader & library
Certification	IEC 60950, Class A / FCC part 15, ICES-003, CISPR 22, EN55022 Class A, VCCI, CNS 13438, KN22, AS/NZS CISPR 22, EN61000-3-2, EN61000-3-3 EN55024, KN24 CE, VCCI, GS, FCC, ICES, NRTL, GOST, BSMI, KCC
Product color	Black
Standard interfaces	Fiber Channel

Weight and Dimensions

Weight	23800 g