Quantum Scalar i80 Quick Start Guide

40 Configuring Your Library For SKM
Quantum Scalar Key Manager 2.5 Quick Start Guide
Configuring the
Scalar
i2000/i6000 Tape
Library
Perform these steps, in order, on the Scalar i2000/i6000 library only.
See the library user’s guide or online help for detailed instructions on how to
complete each of these steps.
1 Install the Encryption Key Management (EKM) license on your library.
2 Prepare partitions for library-managed encryption:
a Install HP LTO-4, HP LTO-5, and/or HP LTO-6, or IBM LTO-5, IBM LTO-6, and/or
IBM LTO-7 tape drives in the library, if not already installed. Unload all tape
cartridges from these tape drives.
b On the tape drives, install the latest version of firmware that is qualified for the
library firmware installed on your library. Refer to the library release notes for
the correct version of tape drive firmware.
3 TLS certificates must be installed on the library as well as on the SKM server. Verify
the appropriate TLS communication certificates are installed on the library. If you
installed your own TLS certificates on the SKM servers, you must install your own TLS
certificates on the library. If you used Quantum-supplied TLS certificates on the SKM
servers, you must use Quantum-supplied certificates on the library.
4 Configure the SKM server IP addresses and generate data encryption keys.
a On the library’s remote Web client, navigate to the EKM server configuration
screen.
b Enter the SKM primary and secondary server IP addresses or hostnames in the
fields provided.
c Click OK.
Data encryption keys are generated. As soon as you apply the SKM server IP
addresses, the library automatically triggers each SKM server to generate a set
of unique data encryption keys. The key generation process should take 30
minutes or less to complete, depending on network performance. The library
generates a RAS ticket when the process is complete. Wait until you receive this
ticket before going to the next step.
Note: If the key generation fails, the library generates a RAS ticket. Follow the
instructions in the ticket to resolve any errors, then initiate manual key
generation by changing the encryption method on an SKM partition to
Enable Library Managed (as described in
Step 5 below). If key
generation continues to fail, run EKM Path Diagnostics to help
determine where the problem lies.
5 Configure partitions for library-managed encryption.
a On the library’s remote client, navigate to the EKM partition configuration
screen.
b For each partition in which you will use SKM, in the Encryption Method drop-
down list, select Enable Library Managed.
c Click OK.

Quantum Scalar i80 Specifications

General

Power supply type	AC
Power requirements	100 – 240V, 50/60Hz
Power consumption (typical)	200 W
Dimensions (WxDxH)	445 x 793 x 264 mm
Media types supported	2x LTO-4
Maximum supported storage capacity	128 TB
Storage temperature (T-T)	-40 - 60 °C
Operating temperature (T-T)	10 - 35 °C
Operating relative humidity (H-H)	20 - 80 %
Media type	Tape Cartridge
Form factor	6U
Product type	Storage auto loader & library
Certification	IEC 60950, Class A / FCC part 15, ICES-003, CISPR 22, EN55022 Class A, VCCI, CNS 13438, KN22, AS/NZS CISPR 22, EN61000-3-2, EN61000-3-3 EN55024, KN24 CE, VCCI, GS, FCC, ICES, NRTL, GOST, BSMI, KCC
Product color	Black
Standard interfaces	Fiber Channel

Weight and Dimensions

Weight	23800 g