Quantum Scalar i80 Quick Start Guide

24 Installing and Configuring the SKM KVM Servers
Quantum Scalar Key Manager 2.5 Quick Start Guide
Note: The default SKM VM server IP address is: 192.168.20.4.
14 When finished press <Enter>.
A message lets you know there are no certificates loaded on the SKM server.
15 Press <Enter>.
The list of SKM Admin commands displays (see Figure 8). If you made any mistakes
during the setup wizard, you can go back and change them by typing the number
corresponding to the item you want to change at the command prompt.
Figure 10 SKM Admin
Commands
16 At the Command prompt, type q and press <Enter> to quit, save your changes,
and restart the SKM key server. This process takes a few seconds.
Note: You MUST quit at this point. Otherwise your changes will not be saved and
you will not be able to continue the installation process.
17 Complete steps 1-16 on the secondary SKM node before proceeding.
18 When you are finished, do one of the following:
• For pre-SKM 2.4 (240Q) systems, proceed to Installing TLS Certificates on the
SKM Server for Pre-SKM 2.4 (240Q) on page 25.
• For SKM 2.4 (240Q) and later systems, proceed to Installing TLS Certificates on
the SKM Server for SKM 2.4 (240Q) or Later on page 28.
19

Quantum Scalar i80 Specifications

General

Power supply type	AC
Power requirements	100 – 240V, 50/60Hz
Power consumption (typical)	200 W
Dimensions (WxDxH)	445 x 793 x 264 mm
Media types supported	2x LTO-4
Maximum supported storage capacity	128 TB
Storage temperature (T-T)	-40 - 60 °C
Operating temperature (T-T)	10 - 35 °C
Operating relative humidity (H-H)	20 - 80 %
Media type	Tape Cartridge
Form factor	6U
Product type	Storage auto loader & library
Certification	IEC 60950, Class A / FCC part 15, ICES-003, CISPR 22, EN55022 Class A, VCCI, CNS 13438, KN22, AS/NZS CISPR 22, EN61000-3-2, EN61000-3-3 EN55024, KN24 CE, VCCI, GS, FCC, ICES, NRTL, GOST, BSMI, KCC
Product color	Black
Standard interfaces	Fiber Channel

Weight and Dimensions

Weight	23800 g