GL300 Manage Tool User Guide
TRACGL300MT001 - 5 -
2. GL300 Manage Tool Interface
GL300 manage tool is PC software which can be used to configure GL300 through
Data_Cable_M. It is easy for the backend server developers to configure GL300 with manage tool,
which has friendly user interface. The correct command messages sent to GL300 will be displayed
on the manage tool. (These messages can also be sent by SMS or GPRS ).
The administrators can also use the manage tool to configure GL300 before selling. But it is
strongly recommended to establish a backend server and implement the way to control GL300 by
SMS or GPRS. Please refer to “GL300 @Track Air Interface Protocol” for detail.
Before using the manage tools please find “PL2303_Prolific_DriverInstaller_v1417.zip” in
develop suit and install the driver for PL2303. After that a new COM port can be found in the PC
system, and then please follow the steps as below:
1. Power on GL300.
2. Connect GL300 to PC with Data_Cable_M.
3. Run “Queclink GL300_Manage_Tool_Vx.xx.exe”.
2.1. System Requirements
In order for this manage tool to run on your computer, you must use it in below operating system:
♦ Windows 98SE;
♦ Windows ME Windows 2000 SP4;
♦ Windows XP SP2 and above (32 & 64 bit);
♦ Windows Server 2003 (32 & 64 bit);
♦ Windows Server 2008 (32 & 64 bit);
♦ Windows Vista (32 & 64 bit);
♦ Windows 7 (32 & 64 bit);
Supported System Environments:
♦ Microsoft .NET Framework 2.0 or higher
To Next Page
Loading...
Need help?
General
