2 - Supplied parts
EN
BTR185 INSTALLATION AND USE MANUAL - REV009A
27
BTR185
2.0 - Standard supply and parts contained in the package
• Retractable thruster
• O-ring
• Hinge
• Lid bracket
• Steel cable
• Installation and use manual
• Conditions of warranty
2.1 - Tools needed for installation
• Phillips screwdriver
• Cutting nipper
• Drill and drill bits Ø 8,5 mm
• Hexagonal wrenches 2,5 mm
• Fork or polygonal key 8 mm and 13 mm
TSC THRUSTER
MAIN SWITCH
COMMAND
TFH3 - TFH6 FUSEHOLDERS
TMS THRUSTER MAIN SWITCH
CONTROL PANELS
STERN
BOW
TCD 1022 TCD 1042 TCD 1044 TCD 1062
3 - Safety BTR185
2.2 - Quick
®
accessories for activation
of the retractable thruster
• Remote control TCD 1022
• Remote control TCD 1042
• Remote control TCD 1044
• Remote control TCD 1062
with integrated line switch control
• Thruster main switch command TSC
• Thruster main switch TMS
• THF3 fuseholders
• THF6 fuseholders
3.0 - Warnings
• The thruster Quick
®
have been designed and manufactured for nautical use.
• Do not use these appliances for other uses.
• Quick
®
shall accept no responsibility for direct or indirect damages caused by improper use of the appliance or an
improper installation.
• The thruster is not designed for maintaining loads generated in particular atmospheric conditions (storms).
• It is strongly recommended to entrust a professional with the positioning and presetting of the counter ange on
the hull. These instructions are generic, and do not show by any means the details of the operations of presetting the
counter ange, which falls under the competence of the shipyard. In case of problems caused by a defective installa-
tion of the tunnel, the installer will be held responsible.
• Do not install the electric motor near easily inammable objects.
To Next Page
Loading...
Need help?
General
