Quick BTR185 Series User Manual

EN
BTR185 INSTALLATION AND USE MANUAL - REV009A
35
BTR1854 - Installation
4.6 - Adjustment procedure
WARNING: the following procedure must be carried out by qualied personnel.
WARNING: presence of moving mechanical parts. Pay extreme attention when operating on the BTR propeller if con-
nected to power.
The thruster is already adjusted at the factory, so it
shouldn’t need any closing adjustment.
8/10 mm
10 A
CN1
CN2
CAN1
CAN2
UP DWN
CN3
POWER
LA STATUS
ERROR
LA
+ LA - LSC
COM COM C - COMC - SXC - DXI - SXI - DXLSO
g. 18
A
C
B
g. 19A
g. 17
RTC R1
PCB RTC R1
• Ensure that all electrical connections have been properly carried out.
• Remove the cover from the board box (g.17).
Limit switch adjustments must be made in “manual mode”.
• Holding down both buttons on the board (g. 18), connect power to the RTC R1 electron-
ic control board until the (green) POWER LED begins ashing rapidly (g. 18 / part. A).
Then release both buttons.
• It is now possible to electrically control the actuator by means of the UP and DOWN but-
tons.
• Press the DOWN button till the actuator can be hooked again to the lever (section 4.4 -
g. 15 part A).
• By pressing the DOWN button, the thruster opens till the activation of the limit switch
and the STATUS LED becomes green (g.18 part B).
If the limit switch isn’t in the correct position (g. 19A), it can be adjusted (see section 4.7).
F
• By pressing the UP button, it is now possible to check the clos-
ing of the lid; once the limit switch is reached the STATUS LED
becomes red: if this closing is not enough, adjust the limit switch
(see section 4.7).
g. 19B
WARNING: make sure that the constant-velocity joint is
straight, at an angle between -5° and +5° (Fig. 19B).
± 5°
DOUBLE JOINT

Quick BTR185 Series Specifications

General

Brand	Quick
Model	BTR185 Series
Category	Outboard Motor
Language	English