Rath Command Center User Manual

Page 8 Page 9
Registering Emergency Phones
Follow the instructions provided with the Emergency Phones to register the phones to the system. If network
information is provided to RATH® at the time of purchase, phones will already have the registration information
entered.
After all phones are registered, verify that all of them show up on the system and show registered. Log into the
Distribution Module and scroll down to VoIP Conguration in left side menu. Click SIP Extension Status, this will
allow you to see all connected devices. If any device shows Not Registered, the information entered into the
Distribution Module does not match what was entered in the Emergency Phone. This needs to be corrected.
Emergency Phone Programming
Phones should be programmed for Memory Location 1 to dial 3931 to call the Command Center rst.
1. Press ENTER to enter Programming Mode
2. Press 1, ENTER, 3931, STOP
3. Press and hold STOP for 3 seconds to exit Programming Mode
The system can be programmed to dial an outside number if the call is not answered at the Command Center.
To do this, perform the following steps at the Command Center:
1. Press the speaker phone button
2. Dial 1, 3, 4
3. Dial 9, the external number, #, * to store the number
4. Verify the Command Center display shows “Forwarded On” followed by the phone number entered
5. Press the speaker phone button to hang up
Note: To turn off call forwarding, dial 1, 3, followed by the GREEN button.

Rath Command Center Specifications

General

Brand	Rath
Model	Command Center
Category	Conference System
Language	English